Product Description
The ADJ Mega Bar RGBA is a 1 - Meter (42 - inch) indoor linear lighting fixture that's perfect for stage or wall washing. It offers amazing RGBA (Red, Green, Blue & Amber) color mixing, giving you a nearly endless color palette. You can operate this fixture in multiple ways. Use the optional ADJ RFC wireless remote (not included) to control features like black - out, built - in programs, flash, DMX addressing, and RGB color change. You can also use a DMX Controller or switch to Sound Active mode. This fixture uses long - lasting LEDs rated at 50,000 hours and has a maximum power draw of just 32W. With its 4 - button LED display, you can easily change the DMX addressing. There's no duty cycle, and you can daisy - chain the power between units using the built - in IEC power Ins/Outs. Key features include multi - colors, six operating modes, 0 - 100% electronic dimming, a built - in microphone, DMX - 512 protocol, 3 - pin DMX connection, seven DMX modes, compatibility with the ADJ RFC wireless remote, and power cord daisy - chaining. Technical specs: It has 320, 10mm RGBA LEDs (64 Red, 96 Green, 96 Blue & 64 Amber), 7 DMX Channel modes, 6 operational modes, 48 built - in color macros, LED pulse & strobe effect, flicker - free operation, 30 - degree beam angle, linkable via 3 - pin XLR cable, comes with mounting brackets, and has a magnet system on end - caps. It has low power consumption, very low heat output, multi - voltage support (100 - 240V, 50/60Hz), dimensions of 41.75 x 3 x 5.75 / 1060 x 73 x 145mm, and weighs 6 lbs. / 2.7 kg.
Using the ADJ Mega Bar RGBA is easy. First, decide how you want to control it. You can use the optional ADJ RFC wireless remote (you'll need to buy it separately). Just aim the remote at the unit and use it to change settings like turning the lights off (black - out), running built - in programs, making the lights flash, setting the DMX addressing, and changing the RGB colors. Or, you can use a DMX Controller or switch to Sound Active mode where the lights react to sound. When it comes to power, you can daisy - chain the units together using the IEC power Ins/Outs on the back. You can connect up to 20 units this way. The 4 - button LED display on the rear panel is useful for changing the DMX addressing. For installation, it comes with mounting brackets, so you can mount it on a wall or just set it on the ground. If you want to connect multiple bars, use the magnet system on the end - caps. As for maintenance, since the LEDs are rated for 50,000 hours, you won't have to replace them often. Keep the fixture clean and dry. Avoid exposing it to extreme temperatures or humidity. Also, make sure to use the correct voltage (it supports 100 - 240V, 50/60Hz) to prevent any damage. And remember, there's no duty cycle, so you can run it all night without any issues.
